Tools that will be needed to cut and install the privacy panels are:
Measure the area you would like the privacy picket panels to cover.
ALL MANUFACTURES VARY so this is important to measure the length of your pickets. Measure from the bottom of your channel to the top of your bottom channel, this will give you a dimensions to start cutting your pickets. We recommend your measurement and then cut a ¼" shorter. This will allow for expansion.
Cut panels, extender clips and U-locks to size. Start snapping them on the fence. Take your fingers and pry open the top of the privacy panels. Line up with the picket and just snap on, making sure it's secure all the way down.
Continue to snap on all privacy picket panels until the fence is complete. If you want your fence to stay private at all times than use the Hurricane U-Locks to snap on the back of the privacy panels. The U-Locks can be removed or put on at anytime depending if you want total privacy or you want them open for a breeze or a view.
CAUTION
Important Installation Information:
Do not store or leave exposed panels in Direct Sunlight
Please keep Privacy Picket Panels covered until You are ready to cut and attach to fence pickets. Open the boxes from the side to avoid damaging the panels and please don't just dump them out on concrete or driveway.
Only install when above freezing.
Cut panels and clips ¼" shorter for expansion.
Please handle with care YOU CAN DAMAGE THEM.
Watch our Video
Copyright © 2020 Hurricane Mfg. Co. LLC - All Rights Reserved.